Chapter 4: Working with Tracks 87
To adjust stereo channel PAN:
1 Press the PAN master switch a second time. The scribble
strips will now show “R<>” in the left side of their display,
and the PAN switch LED will flash. Pressing PAN again will
toggle back to control of left pan.
2 Turn the data encoder to adjust pan.
PAN value display
The LED display above the encoder LED ring provides alpha
numeric pan position data similar to Pro Tools. Stereo chan-
nels will show an “L” or “R.” For example, the pan values for
a stereo aux track panned full out would be “L< -100” and
“R > +100. –100 to –1 is displayed as “<“and +100 to +1 is
displayed as “>.” Center (or, 0 pan value) is shown as “<>.”
If automation is globally enabled for pan, data can be re-
corded to the channel strip’s pan automation playlist. The
encoder defaults to mono channel or left side of stereo PAN.
MON/Ø (Auto Input and Input Only
The MON/Ø switch displays the current input mode (Auto
Input or Input Only).
To check input monitor mode status:
■ Press and hold the MON/Ø switch.
INPUT and OUTPUT Switches
The INPUT or OUTPUT switches let you assign channel in-
put and output in combination with the master ASSIGN
switch. Input and output routing is covered in
Chapter 5: Recording.
R > +100L< -100
Input 1 Bus 3-4
Comments to this Manuals