American Audio DIGI-PRO User's Guide download pdf (Page 162)

ProControl Guide156

To access another Plug-In page using the CHANNEL MATRIX

■ While a Plug-In is in edit mode, press any lit switch in the

CHANNEL MATRIX. Its Matrix switch will ﬂash, showing

that it has become the active page choice.

(Check with the developer of your Plug-Ins to see if they are

fully ProControl-aware, especially in regards to paging and

the BYPASS/IN/OUT/Ø switch.)

Sends

Introduction to Send Options

There are two methods you can use to assign and view sends

with ProControl, one initiated from the fader section, and

one using the special SENDS controls of the DSP EDIT/AS-

SIGN section.

You can use either method as the flow of your project de-

mands.

Method 1: Assigning and Viewing Sends from the Fader section

From the Fader section, you can assign sends on a channel-

by-channel basis using the SELECT/ASSIGN switches and

channel rotary encoders. With this method, the focus is on

a single send. For example, you can set the same Send rout-

ing for a selection of eight (or more) channels in order to

buss them all to the same Aux Input or I/O effects loop.

Method 2: Assigning and Viewing Sends using the DSP

EDIT/ASSIGN section

When you want to work with more than one send at a time

on a channel, use the SENDS features in the DSP EDIT/AS-

SIGN section. In this mode, the focus is on all ﬁve sends for

a single channel.

For example, you can display and adjust the send level,

pre/post status and/or mute for one, two, three, four or all

five sends on any single channel. This can be useful when

working with mixing stems through sends and managing

multiple cue or effects mixes.

1 2 ... 157 158 159 160 161 162 163 164 165 166 167 ... 227 228

No comments

American Audio DIGI-PRO User's Guide Page 162