American Audio DIGI-PRO User's Guide download pdf (Page 13)

Chapter 2: Installing ProControl 7

Assembling an Expanded System

Attaching Fader Packs to a Main Unit

Expanded systems can be bracketed together or left free-

standing, depending on your preference.

You can arrange units in any physical order; putting one

Fader Pack at the far left, the Main Unit in the middle, and

Fader Packs 2 and 3 to the right, or place the main unit at

the far left. The most common arrangement is one where

the main unit remains centered, as close to the “sweet spot”

of the mix environment as possible.

If you decide to leave the units free-standing, you can skip

this section and proceed to “Hardware Connections” on

page 9.

If you want to bracket the units together for greater stability

or flush mounting, do the following:

To attach a Fader Pack to a Main Unit using the included

mounting brackets:

1 Locate the two mounting brackets included with the

Fader Pack.

2 Make sure the units are NOT plugged in or powered on.

3 Remove the appropriate side panel from the main unit by

removing the six screws (four longer screws, and two

shorter ones—extras were included with the unit). Note

where the longer screws are used. If you plan to reattach the

side panel to your system, set the screws aside.

4 Place the ProControl main and Fader Pack units on a table

and position the units so their front or rear panels hang

over the edge of the table. If necessary, prop the unit up to

gain access to the brackets.

Removing the side panels

Front

Rear

NE PAS OUVRIR

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 227 228

No comments

American Audio DIGI-PRO User's Guide Page 13