Chapter 7: Plug-Ins and Sends 159
Adjusting SEND Levels
You can adjust mono or stereo send level from either the
channel data encoders or from the DSP EDIT/ASSIGN sec-
tion. The only difference between these methods is your
view of Send data. Channel-based send editing lets you view
and adjust one send (A/F or D/I, or B/G, and so on) at a time
across all channels. Using the DSP EDIT/ASSIGN encoders
lets you instead view and adjust all the sends (A/F and D/J
and B/G and so on) on any one channel at once.
FLIP mode provides additional ways to control sends and
their parameters. (See “Using the FLIP Switch” on page 160
for instructions.)
To adjust send level from the Fader section:
1 Press a master SEND switch (A/F-E/J) in the SELECT/AS-
SIGN section. The data encoders display send name and
level.
2 Rotate a data encoder to adjust send level.
To adjust send level from the DSP EDIT/ASSIGN section:
1 Select a channel for editing by pressing the channel
INS/SEND switch.
2 Press SENDS in the DSP EDIT/ASSIGN section to place the
DSP EDIT/ASSIGN section in SENDS view. The LEDs will list
all five sends for the current channel.
3 Rotate a DSP EDIT/ASSIGN encoder to adjust the corre-
sponding send level.
4 To switch to another channel for additional send editing,
press the corresponding channel INS/SEND switch.
Display of Send Parameters
While working with sends, the channel and DSP EDIT/AS-
SIGN encoder LED displays indicate send information as
follows:
DVr-10.5 SlS 4.8
SELECT / ASSIGN
OUTPUTINPUT
PAN MON / Ø
SEND
B / G
SEND
E / J
SEND
A / F
SEND
D / I
SEND
C / H
FLIP
ASSIGN
SEND MUTE
Comments to this Manuals