American Audio DIGI-PRO User's Guide download pdf (Page 40)

ProControl Guide34

Setting Pre- and Post-Roll Amounts

To enter a Pre/Post-Roll Time:

1 Hold down c - (CTL) and then press PRE or POST. The ap-

propriate switch LEDs (PRE or POST) will ﬂash, indicating

that PRE/POST entry mode is active.

2 Type values for PRE/POST using the numeric keypad.

Press the ProControl PREVIOUS or NEXT switches to tab

through the numeric ﬁelds.

3 Press ENTER to set the time values. Press ESCAPE to cancel

changes.

Deﬁning in/out points

To deﬁne selection in and out points during playback:

1 Make sure AUDITION is off.

2 While Pro Tools is playing, press IN to deﬁne selection

start, then press OUT at the desired selection end.

AUDITION Mode and PRE, IN, OUT, POST

The AUDITION switch toggles Audition mode on and off.

When on/lit, playback can be controlled from the PRE, IN,

OUT and POST switches (detailed below) to quickly listen to

the either selection start or end, with or without pre- and

post-roll as described below.

Example of AUDITION Mode Playback Options

To understand what PRE, IN, OUT and POST let you do

while in Audition mode, let’s assume you currently have a

four bar selection spanning bars four through 8, with one

bar of pre-roll and one bar of post-roll already defined:

PRE Plays audio starting at the pre-roll point up to the be-

ginning of the selection. In our 4 bar selection example, this

would play from bar 3 to bar 4.

IN Plays audio starting at the selection start through the

length of the post-roll amount. In our example, this would

play from bar 4 to bar 5.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 227 228

No comments

American Audio DIGI-PRO User's Guide Page 40