American Audio DIGI-PRO User's Guide download pdf (Page 191)

Chapter 8: Mixing 185

Write to Start/End/All

When recording or trimming automation levels it is often

desirable to write your current setting to an entire selec-

tion/track, all the way back to the beginning or to the end

of an entire selection or track. ProControl lets you do this

with any automation setting or Trim value. Write to

Start/End/All are available in all automation recording

modes including Write, Touch and Latch, as well as Trim

mode.

When using Write to Start/End/All function, keep in mind

that every enabled automation parameter will be affected,

not just fader level. For example, let’s assume you have

Plug-In automation on a channel, and the master Plug-In

automation switch is enabled. If you choose to write vol-

ume to end, all the Plug-In automation past that point will

be removed. For this reason, use these functions with cau-

tion. Be sure to disable the master automation mode

switches that do no apply to the task at hand.

Write to Start

You can write any current automation value or trim value

back to the beginning of a selected region or to the begin-

ning of the track during an automation record or Trim pass.

To write a new or trim value to the start of a track or selection.

1 Enable a TRIM mode using the method explained in the

previous section “TRIM Automation Mode” on page 182.

2 Be sure the channel is in the desired automation mode,

and that the desired automation parameters are enabled in

the AUTOMATION/ENABLES section.

3 Begin automation recording and adjust parameters as

needed.

4 While still playing back during or immediately after mak-

ing your adjustments, press and hold the CTL/CLUTCH

switch and then press the RTZ switch. This switch is located

immediately to the right of the ON-LINE switch in the

transport section.

The transport will automatically be stopped and the last

level value recorded in this automation mode will be the

1 2 ... 186 187 188 189 190 191 192 193 194 195 196 ... 227 228

No comments

American Audio DIGI-PRO User's Guide Page 191