Chapter 4: Working with Tracks 79
To select more than one channel at a time
■ Hold down the SHIFT/ADD key, then press additional
channel SELECT switches.
To deselect a channel:
■ Hold down SHIFT/ADD, then press the appropriate chan-
nel SELECT switch.
SELECT Switch Shortcuts
◆ Hold down the OPT(ALT)ALL switch, then press any SE-
LECT switch to select/deselect all channels (including off-
bank channels).
◆ Hold down the c (CTL) switch, then press any lit SELECT
switch to change the SELECT status of that channel strip,
and change all other channel strips to the opposite state.
✽ You can also select channels from the CHANNEL MATRIX. See
“The CHANNEL MATRIX” on page 64.
Channel Automation Controls: AUTO
Switch
The AUTO switch is located above the SELECT switch. Next
to the switch are five 2-character LED automation mode in-
dicators, arranged vertically.
The AUTO switch is used to set the channel automation
mode, and to punch in/out on that channel during an au-
tomation record pass. MIDI channel volume, pan and mute
can be automated just like audio tracks.
The 2-character LEDs next to the AUTO switch indicate the
various automation modes and their present status. The
AUTO modes are indicated by the labels as follows:
WR LED (red) Indicates Write mode.
TC LED (red) Indicates Touch mode.
LT LED (red) Indicates Latch mode.
ASSIGN / MUTE
SELECT
SOLO
MUTE
AUTO
+6
0
-10
-15
-20
-30
-90
-40
-60
-5
+3
+6
0
-10
-15
-20
-30
-90
-40
-60
-5
+3
PRE / POST
RD
TM
LT
TC
WR
AUTO
RD
TM
LT
TC
WR
Comments to this Manuals