American Audio DIGI-PRO User's Guide download pdf (Page 206)

ProControl Guide200

Step Test Mode

Step test mode places the faders on Pro-

Control Main and Fader Expansion units in

a test mode where the faders jump, lock-

step, to fader positions which are deter-

mined by adjusting the scrub/shuttle

wheel. When this mode is ﬁrst engaged,

the faders will jump to mid position (ap-

proximately. 512 steps).

■ Rotate the scrub/shuttle wheel to adjust

the step level which the faders use. Turning

the wheel to the left decreases the step level

while rotating the wheel to the right in-

creases the step distance.

Cycle Test Mode

Cycle test mode places the faders on Pro-

Control Main and Fader Pack Expansion

units in a test mode where the faders cycle,

lock-step, from the bottom of the fader

throw to the top in a continuous cycle. The

speed at which the faders cycle is deter-

mined by the scrub/shuttle wheel. The

fader position values are shown in these

scribble strips and are updated in real-time

as the group of faders is moved. Values will

range from off (value of “0”) to full-on

(value of “1023”).

Sine Test Mode

Sine test mode places the faders on Pro-

Control Main and Fader Expansion units in

a test mode where the faders cycle, in a sine

wave shape, from the bottom of the fader

throw to the top. Very hypnotic. The speed

at which the faders cycle is determined by

adjusting the scrub/shuttle wheel.

■ The fader position values will be shown

in these scribble strips and will be updated

in real-time as the group of faders is moved.

Values will range from off (value of “0”) to

full-on (value of “1023”).

■ Rotate the scrub/shuttle wheel to adjust

the sine cycle speed. Turning the wheel to

the left decreases the speed while rotating

the wheel to the right increases the cycle

speed.

Group Test Mode

Group test mode places the faders on Pro-

Control Main and Fader Expansion units in

a mode where the faders become grouped

and may be moved in unison to test group

response. It also displays which fader(s) is

currently being touched by showing the

letter “T” in the fader display.

Touch Test Mode

Touch test mode places the faders on Pro-

Control Main and Fader Expansion units in

a test mode where the Fader Section lower

scribble strips indicate when a fader has

been touched and at what frequency the

fader is currently recognizing.

The fader frequency value will be shown in

these scribble strips and will be updated in

real-time as a fader (s) is touched. The

fader(s) currently touched will additionally

show the letter “T” in its corresponding

scribble strip.

Recal Mode

Recal places the faders on ProControl Main

and Fader Expansion units in a test mode

which recalibrates the faders to factory

speciﬁcations. This is identical to the cali-

bration which occurs at power-on of Pro-

Control Main and Fader Expansion units.

1 2 ... 201 202 203 204 205 206 207 208 209 210 211 ... 227 228

Comments to this Manuals

No comments