American Audio DIGI-PRO User's Guide download pdf (Page 24)

ProControl Guide18

To connect an external Talkback or

Listenback mic:

■ Connect your external Listenback mic

signal to the ProControl External Listen-

back Mic In (found on the Audio Input 1

connector, channel 1).

■ For an external Talkback mic, connect

the appropriate signal to the ProControl

External Talkback Mic In (Audio Input 1,

channel 2).

EXT TALKBACK and LISTENBACK TRIM

There are also trim pots labeled “EXT

TALKBACK TRIM” and “LISTENBACK

TRIM” which may be used to trim the lev-

els of either an external talkback mic or lis-

tenback mic.

Because ProControl includes a Slate/Dub

(Rerecord) bus, you can route and record

the signals from the Talkback bus to

Pro Tools audio interface inputs, where the

audio signals can be recorded to a disk track

(or any appropriate destination). For de-

tails about connections for Slate/Dub/Re-

record, see “Slate/Dub (Rerecord) Output

Connection” on page 18.

Output Connections for Stereo

Mode

Main and Alternate Speaker Connections

■ Connect your main (primary) control

room monitor/amp to the ProControl

CONTROL ROOM OUT left/right outputs

(Audio Output, channels 7 & 8). These

speakers will now be under the control of

the MAIN (1-6) level control.

■ Connect your secondary reference mon-

itors/amp (if any) to the CONTROL ROOM

ALT OUT left/right outputs (Audio Output,

channels 3 & 4). This will allow you to se-

lect and adjust the level of this set of speak-

ers using the ProControl ALT (3-4) source

switch and level control.

☞ For cue/headphone systems, use the AUX

OUT L/R bus as explained in “Connecting Cue

Mix systems” on page 16.

Slate/Dub (Rerecord) Output

Connection

The SLATE/DUB left/right output bus (Au-

dio Output, channels 5 & 6) carries the sig-

nal from the ProControl Slate/Dub (Re-

record) bus. Slate/Dub (Rerecord) lets you

record Talkback audio in Pro Tools (or any

recording device). Once you’ve connected

the Slate/Dub output to a Pro Tools audio

interface input, any ProControl input

source (Talkback, Listenback, Main stereo

mix, source 1, 2 or 3) can be routed to the

Slate/Dub bus. This makes it very simple to

record slates, for example.

To use the Slate/Dub bus:

■ To bus Slate/Dub (Rerecord) to Pro Tools,

connect ProControl Slate/Dub Out

Left/Right (Audio Output channels 5 & 6)

to an available input pair of a Pro Tools au-

dio interface (or a DAT machine or other

recording device). If you only plan to

record mono Talkback Slate audio, you can

connect one of the Slate/Dub outputs (this

saves one Pro Tools input for other pur-

poses).

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 227 228

Comments to this Manuals

No comments