American Audio Q-2422 - AUTRE Specifications download pdf (Page 7)

Batteries and Charging

LED Status During Charging

The following LED states indicate battery status when the transmitter is

connected to a charger:

• Green = charging complete

• Green Flashing = battery charge > 90%

• Red = battery charging

• Amber Flashing = battery error, replace battery

GLX-D transmitters are powered by Shure SB902 lithium-ion rechargeable batteries. Advanced battery chemistry maximizes runtimes with zero memory

effects, eliminating the need to discharge batteries prior to charging.

When not in use, recommended battery storage temperature is 10°C (50°F) to 25°C (77°F).

Note: The transmitter will not pass RF or audio signals when connected to the charging cable.

The following battery charging options are available:

Charging from a USB Port

1. Plug the USB charging cable into the charging port

on the transmitter.

2. Plug the cable into a standard USB port.

Charging Times and Transmitter Runtimes

Use the following table to determine approximate battery runtime based

on the duration of charging time. Times shown are in hours and minutes.

Receiver Bay or

AC Power Source

Charging

USB Connection

Charging

Transmitter Runtime

0:15 0:30 up to 1:30

0:30 1:00 up to 3:00

1:00 2:00 up to 6:00

3:00 4:00 up to 16:00*

*Storage time or excessive heat will reduce maximum runtime.

Note: GLX-D transmitters automatically power-off after approximately 1 hour to

conserve battery life if the signal from a linked receiver is not detected.

Installing Transmitter Batteries

Bodypack Transmitter

1. Move the locking lever to the open position and slide the

battery door open.

2. Place the battery into the transmitter.

3. Close the battery door and slide the latch to lock.

Handheld Transmitter

1. Unscrew and remove the battery cover.

2. Place the battery into the transmitter.

3. Replace and tighten the battery cover.

Receiver Charging Bay

The GLXD4 receiver has a built-in

charging bay for the transmitter batteries.

1. Insert the battery into the charging bay.

2. Monitor the battery charging indicator

on the front panel until charging is

complete.

Charging from an AC Power

Source

1. Plug the charging cable into the

charging port on the transmitter.

2. Plug the charging cable into an AC

power source.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Comments to this Manuals

No comments

American Audio Q-2422 - AUTRE Specifications Page 7

Comments to this Manuals

Related products and manuals for Mixers American Audio Q-2422 - AUTRE