American Audio Q-2422 - AUTRE Specifications download pdf (Page 11)

Troubleshooting

Issue Indicator Status Solution

No sound or faint sound

Receiver RF LED on

• Verify all sound system connections or adjust gain as needed (see

Adjusting Gain).

• Verify that the receiver is connected to mixer/amplifier.

Receiver RF LED off

• Turn on transmitter.

• Make sure the batteries are installed correctly.

• Link transmitter and receiver (see Linking topic).

• Charge or change transmitter battery.

Receiver LCD screen off • Make sure AC adapter is securely plugged into electrical outlet.

• Make sure receiver is powered on.

Transmitter indicator LED flashing red Charge or change transmitter battery.

Transmitter plugged into charger. Disconnect transmitter from charger.

Audio artifacts or dropouts

rf LED flickering or off

• Change receiver and transmitter to a different group and/or channel.

• Identify nearby sources of interference (cell phones, Wi-Fi access points,

signal processor, etc...) and shutdown or remove source.

• Charge or change transmitter battery.

• Ensure that receiver and transmitter are positioned within system

parameters.

• System must be set up within recommended range and receiver kept

away from metallic surfaces.

• Transmitter must be used in line of sight from receiver for optimal sound.

Distortion OL indicator appears on receiver LCD Reduce transmitter gain (see Gain Adjustment).

Sound level variations

when switching to different

sources

N/A Adjust transmitter gain as necessary (see Gain Adjustment).

Receiver/transmitter won't

turn off

Transmitter LED flashing rapidly Controls locked. See Locking and Unlocking Controls.

Receiver gain control can-

not be adjusted

N/A Check transmitter. Transmitter must be on to enable gain changes.

Receiver controls cannot be

adjusted

LK shown on receiver display when but-

tons are pressed

Controls locked. See Locking and Unlocking Controls.

Transmitter ID function

does not respond

Transmitter LED flashes green 3 times Controls locked. See Locking and Unlocking Controls.

Transmitter information

does not appear on the

Receiver LCD

N/A Linked transmitter is off or the receiver is not linked to a transmitter.

Transmitter powers off after

1 hour

Transmitter status LED off GLX-D transmitters automatically power-off after 1 hour to conserve battery

life if the signal from a linked receiver is not detected. Make sure that linked

receiver is turned on.

Resetting Components

Use the reset function if it is necessary to restore the transmitter or receiver to their factory settings.

Resetting the Receiver

Restores the receiver to the following factory settings:

• Gain level = default

• Controls = unlocked

Press and hold the link button while turning on the receiver power until

the LCD displays RE.

Note: When reset is complete, the receiver will automatically initiate linking to search

for a transmitter. Press and hold the transmitter link button within five seconds of

powering-on to complete the link.

Resetting the Transmitter

Restores the transmitter to the following factory settings:

• Controls = unlocked

Press and hold the transmitter link button while turning on the transmitter

until power LED goes off.

When the link button is released, the transmitter will automatically initiate

linking to find an available receiver. Press the link button on an available

receiver to relink.

1 2 ... 6 7 8 9 10 11 12 13 14 15

Comments to this Manuals

No comments

American Audio Q-2422 - AUTRE Specifications Page 11

Comments to this Manuals

Related products and manuals for Mixers American Audio Q-2422 - AUTRE