American Audio DCD-PRO300 Owner's Manual download pdf (Page 3)

Power Pro 300. Please take a few moments to read this entire manual,

and be sure to retain this document for futu re reference. Please read

and observe all safety instru ction s detailed on page two (2).

Using the Controls/ Front Panel

Power

The Power Pro 300 can be turned on and off independently via a

switch on the front panel, by signal sensing, or remotely by a

triggered DC input. There is a switch located on the lower edge

of the rear panel of the amplifier to select how you would like to

turn on the Power Pro 300. If you would like to control the unit's

power on/ power off status manually from the front, place the

switch in the unit's power on/ power off status by means of signal

sensing, place the switch in the “Auto On” position. If you would

like to control the unit's power on/ power off status by a DC r emote

trigger, place the switch in the “TRIGGER” position, and connect

the remote triggering device to the terminal labeled “TRIGGER IN”

next to the switch.

Using the controls/ Back Panel

Power

The front panel switch will manually switch the Power Pro 300 on or

off. A blue LED behind the faceplate lens indicates its power status.

Whenever the amplifier's power switch is in the “ON” position and

the amplifier is in “Active” status the lens is illuminate Blue. If the

amplifier is “ON” but in the “Standby” status the lens is illuminated

RED.

You should use a 3.5mm phone plug in the “IN”connector to make

this connection. The tip of the connector is positive, and the sleeve

of the connector is negative. A second terminal in the same block

is labeled “OUT”. This allows for remote turn-on of other devices

when the Power Pro 300 is powered on. Use the same polarity for

the terminals of this plug. Please read the owner's manual for any

devices you are attempting to connect in this manner to ensure

compatibility.

Power Pro 300 Power Pro 300

Note: If any part of this product is damaged or missing,

please call your dealer or Mansion Industry Home

Products directly at 886-2-22189212.

Note: The front panel power switch must be in the “ON”

position for the 12V triggers or “Auto ON” features to operate.

Congratulations on your purchase of Mclelland

Source Switching Amplifier

Power Pro 300

1 2 3 4 5 6

No comments

American Audio DCD-PRO300 Owner's Manual Page 3