American Audio Encore 2000 User's Guide download pdf (Page 27)

©American Audio® - www.AmericanAudio.us - Encore 2000 Instruction Manual Page 27

MIDI TABLE

CUE LEVEL VR 32 71 Mix CH

CUEMIX VR 33 72 Mix CH

CROSSFADER VR 34 73 Mix CH

RELAY SW/LED 14/14 53/-- Mix CH

-- -- -- --

CC-ABSOLUTE (VR)

Control Change messages are sent with status 0xBn, where n is the channel, for the specified CC

controller. Thus the controller MIDI ID is indicated with the channel along with the CC number. The

value from 0x00 to 0x7F, directly related to the location of the controller.

CC-RELATIVE (ENC)

Control Change messages are status 0xBn, where n is the channel, for the specified CC controller.

Thus the controller MIDI ID is indicated with the channel along with the CC number. The value from

0x40 to indicate the change in the controller. This is an offset to 0x40 “one’s complement” notation.

A message with data 0x43 indicates a positive change of 3.

A messages with data 0x31 indicates a negative change of 15.

SWITCH ON/OFF (SW,CENTER,CW,CCW)

These messages are used for switches.

Control Change messages are sent with status 0x9n, SWITCH On and Off value are 0x7F and 0x00,

where n is the channel.

LED ON/OFF (LED)

These messages are used for LED.

Control Change messages are sent with status 0x9n, LED On and Off value are 0x7F and 0x00,

where n is the channel.

PITCH BEND

Pitch Bend messages are status 0xEn, where n is the channel, for the specified controller.

Thus the controller ID is indicated only by the channel.

For accurate changes, the 14 bit data in a pitch bend message is reserved for absolute controllers

which require more than 7 bits of data.

LEVEL LED (LEVEL)

These messages are used for LEVEL.

Control Change messages are sent with status 0x9n, LED Off value is 0x00 and On value is related

to LED amount, 0x01 with one LED, 0x02 with two LED…., where n is the channel.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 36 37

No comments

American Audio Encore 2000 User's Guide Page 27