©American Audio® - www.AmericanAudio.com - Q-2422/SX User Instructions page 9
original level and the microphone is off.
11. CUE MIXING CONTROL -
This functions allows you to monitor the Cue level as well as the Program (main output) level in your
headphones. A channels Cue Level may only be monitored if the channels Cue function is selected.
To select a channels cue function depress the CUE BUTTON (7) that is directly associated with the
specific channel you wish to monitor. You may use the mixing function to blend both the Cue level
and the Program level together. You can vary the output level to either hear more or less of either of
the two levels. Sliding the Cue Mixing fader to the CUE position will allow you to hear more of the
Cue level. Sliding the knob to the PGM position will allow you to hear more of the Program level
(main output). You may also use the Cue Mixing Control to hear either the Cue level or the Program
level exclusively. If the fader is in the full CUE position you will only hear the cue level, if the fader is
in the full PGM position you will only hear the main output. This function will especially be useful for
occasions when an external monitor is not available.
12. CUE LEVEL VOLUME CONTROL -
This knob is used to control the headphone volume output level.
13. MASTER VOLUME CONTROL -
This fader is used to control the master output level (main volume). To avoid distorted output try to
maintain an average output signal level +4 dB. This fader will control the XLR-BALANCED (28) output
jacks and MASTER VOLUME RCA (31) jacks.
14. HEADPHONES JACKS -
This jack is used to connect your headphones to the mixer. Use head phones only rated at 8 ohms to
16 ohms. Most DJ headphones are rated at 16 ohm, these are highly recommended. Always be sure
the CUE LEVEL VOLUME (12) is set to minimum before you put the headphones on.
15. MIC 1 INPUT JACK -
Combination Microphone Plug. This jack will accept a standard 1/4" male plug or a XLR 3-pin bal-
anced male plug. The volume output level will be controlled by the MIC 1 VOLUME CONTROL KNOB
(18).
16. BNC JACK -
This jack is used to supply a 12V DC signal to a gooseneck light, such as the American Audio® GNL-
14.
17. FADER ASSIGN SWITCH -
This is a four position switch that assign a channel to the CROSSFADER (8). When a channel is
assigned to the left side of the CROSSFADER (8) that channels output level will be controlled by the
CROSSFADER (8). Sliding the CROSSFADER (8) to left position will send full volume output to the
MASTER VOLUME LEVEL (13) and sliding the CROSSFADER (8) to right position will cut that chan-
nels volume to MASTER VOLUME LEVEL (13). The reverse is true for the right channel fader assign
switch.
18. MIC 1 and MIC 2 VOLUME CONTROL KNOBS -
These knobs are used to adjust the microphone volume output level of MIC 1 (15) and MIC 2 (38) .
FRONT PANEL - CONTROLS AND FUNCTIONS CONT.
(14 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals