American Audio Professional Power Amplifier User Manual download pdf (Page 17)

©American Audio® - www.americanaudio.eu ELX Series User Manual Page 17

Strip back the wire insulation 1/2” (13mm).

Insert the bare wire into the hole that was revealed by unscrewing the binding post cap. After inserting the wire into the binding post hole,

screw the binding post cap down on the wire.

Important: To reduce the risk of shock or damage to your amplifier, be sure that the wire connected to one binding post does not come in contact

with that of another.

Typical speaker output using bare wire.

Insert bare wire into the binding post and tighten.

7.4 MONO BRIDGE CONNECTIONS

Mono Bridge operation connections will follow the above descriptions however, when operating in Mono Bridge operation the speaker

connections will run between the two positive (red) leads. Use channel two positive output terminal for the negative connection and the channel

one positive output terminal for the positive connection.

7.5 STEREO CONNECTIONS (USING THE NEUTRIK SPEAKON OUTPUT CONNECTORS)

Recent regulatory requirements in Europe have outlawed the use of the dual banana plug and forced amp users to terminate their speaker cables

with spade lugs or bare wire ends. This is not advantageous to most users that want to reconfigure their systems or quickly change out an amp.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 29 30

No comments

American Audio Professional Power Amplifier User Manual Page 17